Item # HMS-PBHMS Pro Series Pull Bar is a 6 biscuits bar, custom built with 4 on the acceleration side and 2 on the braking side of pull bar. Easy to adjust the preload, long lasting biscuits. This pull bar comes with two blue, two green, and two red bushings.
Some of the upgrades that Hammond Motorsports has done is FK Teflon rod ends , Swift ground stainless steel shafts , machining shaft to housing bushings , made holder to use in holding of the pull bar to take apart or rebuild with, do a brake in of bushings beforehand , dyno all bars , made the windows on housing smaller to keep dirt out.
Made in the U.S.A.
Item # HMS-QCPBPLThe HMS Quick Change Pull Bar Plates will locate your pull bar from 2" to 5" in front of the axle tube center line. Includes all bolts and spacers needed. Also, check out the add-on Pull Bar Adjuster, HMS-PBA (sold separately).
Item # HMS-PBAThe HMS Pull Bar Adjuster can be used for rear end housing or the HMS Driveshaft loop / Pull bar mount. Simply loosen the jam nuts and set screw and then adjust side to side without removing the pull bar bolt.
This pull bar adjuster works great with the Hammond Motorsports 9 inch Ford Pull Bar Mount Kit, HMS-1009M.
Made in the U.S.A.
Item # HMS1000KThe HMS complete caster/camber gauge kit with case works on stock spindles and fabricated spindles.
KIT INCLUDES:
Caster Gauge Housing
Intercomp Angle Finder
(5) Adapters
Carrying Case
Item # WEHWEM2884SSpring Cup- Short- Upper;1-8in Thread, 4in Jack Bolt Included; Steel-Black
Item # WEHWM2889-TSpring Cup- Tall- Upper; 1-8in Thread, 9in Jack Bolt Included; Steel-Black
Item # EIB-5.5-9.5-0655.5” OD x 9.5” - 650 lbs/in; Standard Coil Front Spring
Item # EIB-5.5-11-11005.5”x 11” - 1100 lbs/in; Standard Coil Front Spring
Item # EIB-5.5-11-12005.5”x 11” - 1200 lbs/in; Standard Coil Front Spring
Item # EIB-5.5-11-13005.5”x 11” - 1300 lbs/in; Standard Coil Front Spring